[YostBMW]

Sharing a rowdy Whipple Stage II Mustang we just finished at Autobahn West, Inc.

825HP Whipple Stage II Mustang GT S550


https://www.youtube.com/watch?v=oZiGT6irPDo&t=37s

[baege]

PSA: if you see one of these about to leave a cars n coffee, run for your life.

[Grumpy Old Man]

Originally Posted by baege

PSA: if you see one of these about to leave a cars n coffee, run for your life.

I was going to post this exact same thing before I watched the video and you beat me to it.

What could possibly go wrong?

[ScottyRyan2019]

I had a Whippler on a Mustang I use to own. The whine of a twin screw and the instant bewst is a lot of fun .

[yco]

yeah thats right.. this car needs a manual..

[Alfisti]

I'm actually more amazed by how quick it went through the left turn and how stable it looked. NFI why you need 800hp for the street, and a good NA engine would be my preference.

[Rmtt]

Originally Posted by ScottyRyan2019

I had a Whippler on a Mustang I use to own. The whine of a twin screw and the instant bewst is a lot of fun .

Same here. I had a 2004 Terminator at one time. Started off by changing the upper pulley....then the lower pulley....the ported the stock Eaton...then eventually moved to a Kenne Bell 2.8 setup.

Traction was shit....but I was young and it was a very fun car! It put down just a little over 650 to the wheels.

[ScottyRyan2019]

Originally Posted by Rmtt

Same here. I had a 2004 Terminator at one time. Started off by changing the upper pulley....then the lower pulley....the ported the stock Eaton...then eventually moved to a Kenne Bell 2.8 setup.

Traction was shit....but I was young and it was a very fun car! It put down just a little over 650 to the wheels.

Those KB's had even more whine than the Whipple did. How many IRS did you go through? LOL

[Rmtt]

Originally Posted by ScottyRyan2019

Those KB's had even more whine than the Whipple did. How many IRS did you go through? LOL

LOL.....as long as you didn't have a sticky tire...you were good. I couldn't imagine it hooking up and what it would do.

I remember my first Z06...H/C/I....took it to the track within 3 hours of getting it tuned. We only have 1/8 mile strips here. First pass was me spinning all the way up the track.

My friend who had a serious Z06 build said lets bolt on these ET Streets and see what it does. Being naïve and still learning, I agreed.

First pass with those and I snapped one of my half-shafts. That was another rabbit hole which led to a new RPM transmission, new RPM Rear Diff, everything hardened and upgraded, and a trans axle brace.

At least after that...it launched straight no matter how bad I sucked at driving!

[ScottyRyan2019]

I had a buddy with a Termi and he never ran it from a dig, always a roll for that exact reason. Great car, just rode like a lumber truck! LOL.

Those Z06 are beasts!

[YostBMW]

On 315 Michelin Pilot Super Sport tires, the car is a hand-full under 3rd gear. NEEDS STICKY RUBBER

[BeachM5nster]

i vomited in my mouth a lil

so 825 hp mustang means its getting about 350 to the wheels?

jk jk. not about the vomiting tho. lol

[GoneIn4Secs]

Originally Posted by baege

PSA: if you see one of these about to leave a cars n coffee, run for your life.

Or climb a light pole or tree!

[hubbahubba]

Needs X-Drive.

[YostBMW]

Originally Posted by hubbahubba

Needs X-Drive.

AGREED!